Moves the Front Gantry to a position near the Y21- Limit position and the Rear

Gantry to a position near the Y11+Limit position.

§ button

Moves the Front Gantry to the Y21 home position and the Rear Gantry to a

position near the Y11+Limit position.

w group

Carries out Up/Down operation of the Backup Table and Up/Down operation of the

Stopper.

w group

Display the status of the PCB on each station of the Conveyor, click on the

button to remove the error status after solving the problem of the station

where board jam occurred.

13.7. Sts. Info [F9]

The “Production Statistics“ dialog box is a tool added to monitor machine performance. It

is used to check execution time, PCB loading and unloading, and data related to the

placement activities on each head. To update with the most up to date data, click on the

button on the bottom of the window.

13.7.1. Statistics - Production

Displays data related to the production time and production progress.

13-9

2024年7月24日发(作者：空绢子)

Samsung Component Placer CP-60L Operations Manual

Figure 13-6.”Feeder Recovery” dialog box

w button

Click this button to move the camera to the Pickup position.

w button

Click this button to fill the Feeder. Used to be for Matrix Tray Feeder.

w button

Click this button to set the feeder to a ready state after correcting the problem.

w button

When a part is on a nozzle, click this button to verify a pickup position.

w button

With a part on the head to display “Inspect Teach“ dialog box to resolve LSO or

Vision problems.

w button

Used to reset the error status of current feeder, and display the next feeder where a

problem has occurred. If no more problems exist, the dialog box will close.

w button

Closes this dialog box.

Inserting a part of body while the machine is in operation

or in temporary stop could result in severe injury.

Warning

Do not insert a part of body while the machine is in

operation or in temporary stop.

13.6. Conveyor Recovery [F7]

Used to correct the problem occurred during run operation.

Figure 13-7. “Conveyor Recovery” dialog box

w group

13-8

Production Menu

Y2 -Home

Y22Home

X2 +Limit

X2 -Limit

X2 Home

Y1 +Limit

Anti-collision Sensor

Y2 +Limit

Y12 Home

Y11 Home

X1 Home

Y1 -Limit

Y21 Home

+Y

+X

X1 -Limit

X1 +Limit

§ button

Moves the Front Gantry to a position near the Y21- Limit position and the Rear

Gantry to the Y22 home position.

§